Shopping Cart0 item(s) in cart/ Total: $0
A&D-AD-4410 Weighing Indicator

A&D-AD-4410 Weighing Indicator

Your Price: $1,155.00
Retail Price:$1,530.00
You Save:$375.00(25%)
Part Number:A&D-AD-4410

A&D-AD-4410 Vibration-Resistant Weighing Indicator

  • Powerful vibration-cancelling function (High Performance Digital Filter)
  • High speed sampling (100 times/second)/ high accuracy
  • Average holding function
  • RS-232C standard
  • Comparator Function
  • SCF-Statistical Calculation function
  • Comparator Function
Use the AD-4410 to build custom in-line check-weighing systems equipped with DSP technology to eliminate the effects of noise and vibrations from results. Reduce the cost and need for expensive mechanical equipment.

Specifications:

Analog unit
Input sensitivityOver 0.15µV/d (d=minimum division)
Zero adjustment range-35mV to +35mV (-7mV/V to +7mV/V)
Load cell excitationDC5V±5%, 120mA 
Remote sensing function included
Up to 8 load cells (350Ω) can be connected
Temperature coefficientsZero; ±0.02µV/°C (Typ.)
±0.1µV/°C (Max.)
Span; ±3ppm/°C (Typ.)
±15ppm/°C (Max.)
Nonlinearity0.005% of F.S.
Input noiseLess than 0.3µVp-p
Maximum measurement voltage-35mV to +35mV (-7mV/V to +7mV/V)
Input impedanceOver 10MΩ
A/D conversion methodDelta-sigma modulation
Internal resolutionApprox. 16,000,000
Display resolution999,999d (less than 20,000d recommended)
Sampling rate100 times/sec.
CalibrationActual load calibration or digital span 
calibration not using actual load
Digital unit
Display elementsWeighing display: 
7-segment 6-digit green LED 
Character height of 14.6mm
Polarity display: 1 green LED
Situational display: 6 red LEDs
Measurement data displayDisplay switchable between net and 
gross weight
Display range: 0 to 999,999d 
(Select between 1, 2, 5, 10, and 50 for 
minimum division "d")
Units: Affix a "g", "kg", or "t" unit sticker
Status displayZERO, STABLE, GROSS, NET, HOLD and 
a light which can be given a custom 
function by the user
External output components
Standard serial output (ch1)RS-232C 9-pin Dsub (male)
Standard serial output (ch2)20mA current loop signal
(For connection with A&D peripherals)
Control I/O3-point input function selection
(Non-voltage connection point or 
open collector)
3-point output function selection 
(open collector output)
Modbus-RTUSupported with RS-232C (included as 
standard) or RS-232C/RS-485 (optional).
Basic specifications
Power source voltageAC100V to 240V 50/60Hz
Power consumptionApprox. 10VA
Operating temperature and humidity-10°C to 40°C/85%RH or less 
(Condensation must be avoided)
Dimensions144(W) x 72(H) x 125(D) mm/ 5.67" x 2.84" x 4.92"
(Protrusions included, cable excluded)
Panel cut dimensions138 x 68 mm/ 5.43" x 2.68"
Dust/water protectionThe IP65 display when mounted into 
a panel 
(Using included rubber packing
WeightApprox. 800g/ 1.76 lb.